收藏本站
LTM4602
PIN FUNCTIONS
(See Package Description for Pin Assignment)
V IN (Bank 1): Power Input Pins. Apply input voltage be-
tween these pins and PGND pins. Recommend placing
input decoupling capacitance directly between V IN pins
and PGND pins.
f ADJ (Pin A15): A 110k resistor from V IN to this pin sets
the one-shot timer current, thereby setting the switching
frequency. The LTM4602 switching frequency is typically
850kHz. An external resistor to ground can be selected to
reduce the one-shot timer current, thus lower the switching
frequency to accommodate a higher duty cycle step down
requirement. See the applications section.
SV IN (Pin A17): Supply Pin for Internal PWM Controller. Leave
this pin open or add additional decoupling capacitance.
EXTV CC (Pin A19): External 5V supply pin for controller. If
left open or grounded, the internal 5V linear regulator will
power the controller and MOSFET drivers. For high input
voltage applications, connecting this pin to an external
5V will reduce the power loss in the power module. The
EXTV CC voltage should never be higher than V IN .
V OSET (Pin A21): The Negative Input of The Error Ampli?er.
Internally, this pin is connected to V OUT with a 100k precision
resistor. Different output voltages can be programmed with
additional resistors between the V OSET and SGND pins.
COMP (Pin B23): Current Control Threshold and Error
Ampli?er Compensation Point. The current comparator
threshold increases with this control voltage. The voltage
ranges from 0V to 2.4V with 0.8V corresponding to zero
sense voltage (zero current).
SGND (Pin D23): Signal Ground Pin. All small-signal
components should connect to this ground, which in turn
connects to PGND at one point.
RUN/SS (Pin F23): Run and Soft-Start Control. Forcing
this pin below 0.8V will shut down the power supply.
Inside the power module, there is a 1000pF capacitor
which provides approximately 0.7ms soft-start time with
200μF output capacitance. Additional soft-start time can
be achieved by adding additional capacitance between the
RUN/SS and SGND pins. The internal short-circuit latchoff
can be disabled by adding a resistor between this pin and
the V IN pin. This pullup resistor must supply a minimum
5μA pull up current.
FCB (Pin G23): Forced Continuous Input. Grounding this
pin enables forced continuous mode operation regardless
of load conditions. Tying this pin above 0.63V enables
discontinuous conduction mode to achieve high ef?ciency
operation at light loads. There is an internal 4.75k resistor
between the FCB and SGND pins.
PGOOD (Pin J23): Output Voltage Power Good Indicator.
When the output voltage is within 10% of the nominal
voltage, the PGOOD is open drain output. Otherwise, this
pin is pulled to ground.
PGND (Bank 2): Power ground pins for both input and
output returns.
V OUT (Bank 3): Power Output Pins. Apply output load
between these pins and PGND pins. Recommend placing
High Frequency output decoupling capacitance directly
between these pins and PGND pins.
TOP VIEW
A
B
COMP
V IN
BANK 1
PGND
C
E
G
J
L
D
F
H
K
SGND
RUN/SS
FCB
PGOOD
BANK 2
M
N
P
V OUT
BANK 3
R
T
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
4602 PN01
4602fa
6
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
LTM4603HVEV#PBF IC DC/DC UMODULE 6A 118-LGA
LTM4603IV#PBF IC DC/DC UMODULE 6A 118-LGA
LTM4604AIV#PBF IC UMODULE DC/DC LV 4A 66-LGA
LTM4604IV#PBF IC DC/DC UMODULE 4A 66-LGA
LTM4605EV#PBF IC DC/DC UMODULE 5A 141-LGA
LTM4606MPV#PBF IC DC/DC UMODULE 6A 133-LGA
LTM4607IV#PBF IC BUCK/BOOST SYNC ADJ 5A 141LGA
LTM4608AEV#PBF IC BUCK SYNC ADJ 8A 68LGA
相关代理商/技术参数
LTM4602IV#PBF 制造商:Linear Technology 功能描述:DC/DC MODULE IC
LTM4602IV-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:6A High Effi ciency DC/DC ??Module
LTM4602V 制造商:LINER 制造商全称:Linear Technology 功能描述:6A High Effi ciency DC/DC μModule
LTM4603 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual 8A per Channel Low VIN DC/DC μModule Regulator
LTM4603-1 制造商:LINER 制造商全称:Linear Technology 功能描述:6A DC/DC μModule with PLL, Output Tracking and Margining
LTM4603EV#2DPPBF 制造商:Linear Technology 功能描述:6A DCDC UMODULE: NO REMOTE SEN
LTM4603EV#PBF 功能描述:IC DC/DC UMODULE 6A 118-LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入（最小）:66V 电压 - 输入（最大）:160V Voltage - Output 1:12V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:50W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H（116.8mm x 47.2mm x 20.1mm） 包装:散装 工作温度:-25°C ~ 85°C 效率:* 电源（瓦特）- 最大:*
LTM4603EV#PBF 制造商:Linear Technology 功能描述:DC/DC ?Module IC